Digi Connect Series

Configurethedeviceusing theweb interface Network configuration
Digi Connect Family and ConnectPort TSFamily
78
n
Enable: Enables or disables the configured socket tunnel.
n
Timeout (seconds): Thetimeout, specified in seconds, controlshow long the tunnel will
remain connected when there isno tunnel traffic. If thetimeout value iszero, then no timeout
isin effect and the tunnel will stay up until some other event causesit to close.
n
Initiating Host: Thehostname or IPaddressof the network device which will initiate the
tunnel. Thisfield isoptional.
n
Initiating Port: Specify the port number that the Digi device product will use to listen for the
initial tunnel connection.
n
Initiating Protocol: The protocol used between the device that initiates the tunnel and the
Digi device server. Currently, TCPand SSL are the two supported protocols.
n
Destination Host: Thehostname or IPaddressof the destination network device.
n
Destination Port: The port number that the Digi device will use to make a connection to the
destination device.
n
Destination Protocol: The protocol used between Digi device and the destination device.
Currently, TCPand SSL arethe two supported protocols. This protocol doesnot need to be the
same for both connections.
n
Click Add to add a socket tunnel. Click Apply to save the settings. Once the socket tunnel is
configured, select the Enable check box to enable thesocket tunnel.
Advanced Network Settings
TheAdvanced Network Settings define the network interface. These settings rarely need to be
changed. Contact your network administrator for more information about thesesettings.
IP settings
Usethe IPsettingsto manage IPaddressconfiguration.