Configurethedeviceusing theweb interface Network configuration
Digi Connect Family and ConnectPort TSFamily
68
n
Data Encryption: You an select multiple encryption methods.
l
Use any available encryption method: Enablesall of the methods. The capabilitiesof the
wirelessnetwork determinesthe actual method used.
l
Use the following selected method(s): Selects oneor more encryption methods.
l
Open System: Does not use encryption over the wirelesslink. Open System encryption is
valid only with Open System and Shared Key authentication.
l
WEP: UsesWired Equivalent Privacy (WEP) encryption over the wireless link. You can use
WEPencryption with any of the above authentication methods.
l
TKIP: Uses Temporal Key Integrity Protocol (TKIP) encryption over the wirelesslink. You
can use TKIPencryption with WPA-PSKand WPAwith 802.1x authentication.
l
CCMP: UsesCCMP(AES) encryption over the wirelesslink. You can use CCMPWPA-PSK and
WPAwith 802.1x authentication.
n
WEP Keys
l
Transmit Key: Specify the corresponding key of the encryption key used when
communicating with wireless networks using WEPsecurity.
This device allows up to four wirelesskeys to be set of either 64-bit or 128-bit encryption.
Thesekeysallow thewirelessnetwork to traverse different wireless networkswithout
having to change the wirelesskey. Instead, only the transmit key setting has to be changed
to specify which wireless key to send.
l
Encryption Keys: Specify 1 to 4 encryption keysto use when communicating with wireless
networks using WEPsecurity.
Theencryption keys is a set of 10 (64-bit) or 26 (128-bit) hexadecimal characters. The
encryption key only containsthe characters A-F, a-f, or 0-9. Optionally, you can use
separator characters, such as '-', '_', or '.' to separate the set of characters.
n
WPAPSK(Pre-Shared Key) Passphrase/Confirm: The passphrase that the Wi-Fi network uses
with WPApre-shared keys. The pre-shared key is calculated using the passphrase and theSSID.
Therefore, a valid network name must have been previously specified. In the Confirm field,
reenter the passphrase.
n
Username/Password/Confirm: The user name and password combination used to
authenticate on the network when using these authentication methods: WEPwith 802.1x
authentication, WPAwith 802.1x authentication, or LEAP. In theConfirm field, reenter the
password.
Wi-Fi 802.1x authentication settings
Thesesettingsare not required based on the current Wi-Fi authentication settings. They are only
configurable when WEP with 802.1x authentication or WPAwith 802.1x authentication are
enabled on the WiFi Security Settingstab.