Digilite Pulse MX - Page 43

43
PULSE MX
memory to a USB drive and vice versa.
Clear show:
Completely erases all show data including cue lists and patch data, and restores default congura-
tion Fixture libraries and all backup les stored in the internal memory are not erased.
Touch calibrations:
Touchscreen calibration. In general, the console is delivered with a properly calibrated touchscreen,
but it can be newly calibrated whenever needed. To calibrate the screen, touch the spots pointed out
by the programme. To go back to the Setup menu, touch a blank spot on the screen.
DMX-in Playbacks configuration:
Program to congure the remote control of console playbacks by DMX input.
DMX-in Controllers configuration:
Program to congure the remote control of manual cues by DMX input.
Midi configuration:
Program to congure the remote control of the console by MIDI protocol.
Fixture builder:
A programme to create conguration les for a xture not included in the library. In order not to
display the dierent xture’s technical details, the console needs a “xture denition le” for each of
them, consisting in an fdf or fxr le (the console has full compatibility with fxr les from Pilot 3000),
which form the xture library. This library can be expanded by the user by creating new fdf les with
the programme ‘xture builder’ which can be recalled by clicking on the xture builder button.
IMPORTANT: it is recommended not to use this program while executing particularly complex shows
Diagnostic:
Launches the diagnostic programme allowing to verify the good functioning of all hardware and of
the whole system.
IMPORTANT: this function interrupts the console's normal functioning, suspending DMX and Artnet
transmission.
Software upgrade:
This function updates the console to a newer software version. Once the software update is complet-
ed, the console must be restarted. Where specic instructions are not given with the update, insert
the USB drive containing the update le and conrm. After about ten seconds, an “update complete”
message will appear, together with a reminder to restart the console.
Back to editor:
Exits Setup menu and opens the editor.