55
PULSE MX
The two DMX connectors of each output are internally connected, but in order to make sure that the
wiring works properly, it is advised to verify each port twice, using rst one connector and then the
other.
Midi connection test
Connect with a midi cable the midi-in input to the midi-out output and press the Midi button: the
console will transfer a certain number of data packets through the midi-out port and compare them
with the data received from the midi-in input. If the two sets of data match, the test is considered as a
pass; if they do not match, the test is considered as a fail. This test veries at the same time all Midi-in
and Midi-out ports. No test is available for the Midi-thru port.
Smpte test
To test the Smpte port, simply connect a Smpte generator to the corresponding input on the con-
sole. The diagnostic status bar (top right) scrolls the Smpte frames in real time, allowing to verify the
correct reception of the Smpte timecode.
Expansion test 1 and 2
Pressing the buttons Exp.1 and Exp.2 allows to verify the correct functioning of these two expan-
sions. When pressing the button Exp.1, the diagnostic programme receives data from the selected
expansion instead of the internal card of the controllers/playbacks. When expansion commands are
activated, the graphical representation on the screen will respond immediately. Pressing the button
Exp.2 performs the same test on Expansion 2.
Press the Cntrl button to go back to the test of the console’s internal card.
To Next Page
Loading...