Page 69
Control Other Devices with the Remote
Set Up the Remote Control
You can set up the remote to control other device’s using the device codes listed
on page 120.
1. Turn the device on. Use the device’s buttons or its
remote control to turn it on.
2. Find the brand name of the device
in the tables on page 120.
If the brand isn’t listed, please see
the section titled Scan for Device
Codes, below.
3. Press and hold the mode button
until all the other mode buttons
light up, and then let go of the
mode button.
The mode button flashes.
For example, hold the TV mode
button for a TV until all of the
other mode buttons light. When
you let go, the TV mode button
will flash.
4. For Aux mode only. Press 0 for a
second TV, or 1 for a second
VCR, or 2 for a tuner or amplifier.
This step is for programming
which kind of device that should
be programmed in AUX mode. If
you’re not programming in AUX
mode, skip to step 5.
5. Enter one of the three-digit device
codes from the table using the
number buttons.
The three-digit device code should
be for the brand name of your
device that you found in step 2.
6. If you want to program limited
mode, press 1. If not, skip to step
7.
See Limited Mode for more
information.
7. Press the POUND (#) button. If you entered the code correctly,
the mode button flashes three
times.
8. Press the blank POWER button
to turn off the device. If the device
does not turn off, go to step 10.
If the code works, the device
should turn off.
9. Turn the device back on and try
some other buttons to make sure
they work. If the code works for
other buttons, stop here.
Sometimes the POWER button
works when other buttons don’t.
10. If the code doesn’t work, repeat
steps 3-9 with another device code
from the tables.
Try every code listed for your
brand until one works for your
device.
11. If you can’t find a code that
works, try Scan for Device Codes
below.
To Next Page
Loading...
