Distech Controls ECB-VAVS - Using the dc gfxApplications; Accessing the Preloaded Applications with EC-Net Pro

20 ECB-VAVS Preloaded Applications
Using the dc gfx Applications
This chapter explains how to access the preloaded applications using EC-Net Pro and how to navigate
the dc gfx Applications interface. Various aspects of the dc gfx Applications interface are explained, in-
cluding configuring the VAV settings and setting up trends to be followed.
Accessing the Preloaded Applications with EC-Net Pro
The ECB-VAVS preloaded applications can be found in the dc gfx Applications palette.
Certain elements must be installed on the EC-Net platform being used, namely:
£ EC-Net Support Package
£ dcImages
£ Haystack tagging
£ dcgfxApplications
For information on how to prepare an EC-Net station and how to install the dc gfx Applications palette
or module in an EC-BOS, refer to the Productivity Enhancing Tools User Guide .
To access the preloaded applications of an ECB-VAVS controller, it must first be created in the Bcp-
BacnetNetwork driver of the configured station and then matched with an existing device in the BAC-
net Network. The following procedure explains how to add devices to a configured station and then
how to match them with existing devices in the network:
1. Open the dcgfxApplications template.
Using the dc gfxApplications