XF6 Series Installation and Programming Guide Digital Monitoring Products
29
Programming Menu Language
Press CMD to select the programming language.
The current primary programming language displays. The default language is English. Press
a Select key to change the primary programming language.
Select the primary programming language.
ENG = English (ENGLISH)
SPN = Spanish (ESPANOL)
FRN = French (FRANCAIS)
The current secondary programming language displays. Selecting a secondary language
allows the installer to view programming in English, Spanish, or French. When the
Programming Menu is accessed, the installer is prompted to choose the programming
display language. If SEC LANG: is set to NONE, the option to choose a language does not
display. To select a secondary language, press the select key or area below the language.
Default is NONE.
Select the secondary programming language.
NONE = No secondary language options are displayed
ENG = English (ENGLISH)
SPN = Spanish (ESPANOL)
FRN = French (FRANCAIS)
User Menu and Status List Language
Press CMD to select User Language.
The current primary user language displays. The default language is English. Press any
select key or area to change the primary User language.
Select the primary user language.
ENG = English (ENGLISH)
SPN = Spanish (ESPANOL)
FRN = French (FRANCAIS)
The current secondary user language displays. Selecting a secondary user language allows
the user to view the User Menu and Status List text in English, Spanish, or French. When
the User Menu is accessed, the user is prompted to choose the display language. Status
List text displays in the selected language until another language is chosen. If SEC LANG:
is set to NONE, the option to choose a language does not display. To select a secondary
language, press the select key or area below the language. Default is NONE.
Select the secondary user language.
NONE = No secondary language options are displayed
ENG = English (ENGLISH)
SPN = Spanish (ESPANOL)
FRN = French (FRANCAIS)
House Code
When using a DMP wireless system, enter a house code between 0 and 50. Default is 0
indicating no wireless system is being used. The DMP house code identifies the panel, DMP
receiver, and DMP transmitters to each other. The DMP receiver listens for transmissions
that have the programmed house code and transmitter serial number. The transmitters may
take up to two minutes to learn the new house code and continue operation.
Detect Wireless Jamming
This option displays when the House Code entered is for a DMP 1100 Series Wireless
system (1-50). When enabled and the wireless receiver detects jamming, a jammed trouble
displays in the Status List and is sent to the central station receiver. Select YES to enable
jamming messages to display in the Status List. Select NO to disable jamming messages.
Default is YES.
Wireless Encryption
Encryption allows the panel to communicate with encrypted 1100 Series wireless devices.
Select ALL to to allow encryption for all the wireless devices programmed into the panel.
Select BOTH to allow encryption for selected wireless devices programmed into the panel.
PROG LANGUAGE
PRI LANG: ENGLISH
SEC LANG: NONE
USER LANGUAGE
PRI LANG: ENGLISH
SEC LANG: NONE
WIRELESS
HOUSE CODE: 0
DETECT WIRELESS
JAMMING: NO YES
1100 ENCRYPTION
NONE ALL BOTH
To Next Page
Loading...