XF6 Series Installation and Programming Guide Digital Monitoring Products
41
Once you have changed the code, it is important to write it down somewhere and store
it in a safe place. Lost Lockout Codes require the panel to be sent back to DMP for repair.
You may cancel a Lockout Code by entering 00000 at the Set Lockout Code command.
Lockout Code restriction
Do not set a Lockout Code higher than 65535.
APPENDIX
DIAGNOSTICS FUNCTION
The panel contains a Diagnostics function that allows you to test the communication integrity of the LX-Bus™, identify
individual zones, and also display the present electrical state of any zone. The Diagnostics function also allows you
to test the integrity of the cellular communication, and cellular signal.. To use Diagnostics, reset the panel, enter the
Diagnostics code 2313 (DIAG), and press CMD.
Test LX-Bus
This function allows you to test the ability of the panel to communicate with zone and output expander modules
To Next Page
Loading...