Dormakaba ES 250 PRO - Page 73

73
WN 059677 45532 - 11/2023
ES 250 PRO/ES 250 PRO FST
ES 400 PRO/ES 400 PRO FST
Mounting instructions
Display Meaning/cause Troubleshooting/possible causes
E000 Control unit is error-free
E001 Door jammed in opening direction
Incorrect zeroing Remove obstacle Check floor guide Check toothed belt Adjust obstacle detection and force limitation settings Check mechanics and electronics of locking device/drive
E002 Door jammed in closing direction
End stopper moved Remove obstacle Check floor guide Check toothed belt Adjust obstacle detection and force limitation settings Check mechanics and electronics of locking device/drive
E003
Firmware versions do not match (ES250/400 PRO FST only)
Check firmware version and WN of the control unit Update firmware if necessary
E004 Inside detector error (ES250/400 PRO FST only)
Check wiring Check the DIP switch settings on the EMSIAK Check the DIP switch settings on the CAN sensors if applicable, replace SiAK extension module if applicable, replace CAN sensors
E005 Device identifier incorrect
Perform network reset* If the error occurs again, replace the control unit
E006
Emergency open button not detected (on FIA locking device only)
Mount emergency open button (CAN) Check emergency open button (CAN) if necessary
E007 24V controller overvoltage/undervoltage
Perform network reset* If the error occurs again, replace the control unit