Dräger Polaris 50

ENG
32
 After inserting the wall mounting arm, first install the ring “A”,
then the locking ring “B”, followed by the end rings “C”.
 Carefully insert the rotary plug “D”.
 Attach the joint covers “B” and fit screws “C”.
 Attach the covers “A”.
DANGER
Risk of death from electric shock.
 Do not turn on the power supply before the luminaire
head has been installed.
 To proceed with the installation of the luminaire head,
see Chapter 6.
5. INSTALLATION: Polaris 50 Mobile
 Remove the M3 Allen screws on the sides and remove
the power supply tray “A”.
 Loosen the 2 Allen screws on the lower support tube.
 Feed the support tube cable through the roller stand.
 Attach the support tube to the roller stand using the 2
Allen screws and serrated washers (10 Nm).
 The cable holder must be aligned towards the rear.
 Connect the stranded wires of the same colour for the
lower support tube and for the power supply.
 Reinstall the power supply tray with the M3 Allen screws
and serrated washers.
 Push the plugs on the upper and lower support tube
together until they click.
 Place the upper support tube on the lower one.
A
B
C
D
A
A
C
B
A