12
Document/Printing Paper Specifi cation
IMPORTANT
● To make a new plate from a document from which a plate has already been made,
remove and then reload the document.
● Always use documents of the same size.
● If you load documents of different lengths, the printer may not operate correctly.
The following types of document cannot be used:
● Documents with large fi le-binding holes, tears, or missing parts
● Documents with staples or paper clips attached
● Documents with markedly curling ends/sides, or marked folds
● Carbon-backed documents
● Sticky documents
● Highly transparent documents such as OHP fi lm
IMPORTANT
The following types of paper cannot be used.
• Paper with large fi le-binding holes
• Paper with staples or paper clips attached
• Paper with markedly curling ends/sides, or marked folds
• Paper with tears or rough edge
• Chemically treated paper such as thermal paper, carbon paper, and stickers, etc.
• Highly transparent paper such as OHP fi lm and tracing paper, etc.
• Paper with correction fl uid and glue, etc.
• Paper with smaller pieces of glued paper
DP-L220 DP-L210 DP-L200
Paper weight 45–210 gsm
Paper size Max. 297×420 mm
Min. 100×148 mm
Max. 297×364 mm
Min. 100×148 mm
Max. 297×364 mm
Min. 100×148 mm
Paper stacking
capacity
Feed tray : 1300 sheets (64 gsm high-grade paper)
Print tray : When a cabinet is used:1300 sheets (64gsm high-grade paper)
When the printer is used on a table: 900 sheets
(64gsm high-grade paper)
●
Document weight : 64–128 gsm (17lb bond - 34lb bond)
●
Document size : MAX. 297×432 mm (11"×17")
MIN. 100×148 mm (4"×6")
●
Stacking capacity in document tray : 10 sheets (64 gsm)
Acceptable Documents
Acceptable Printing Paper