6
75
Troubleshooting
When Messages Appear
Message Countermeasure
Press the PRINT key and input your ID and
Password.
(→P.11 “UID Control Function”)
Cannot print.
This message is displayed just after the master
setting error or master ejection error occurs.
It is also displayed if you press the
PRINT key or
TEST PRINT key without making a master while
the confi dential safeguard function is activated. Make
a master fi rst.
Printing is not complete.
Either press the
PRINT key to resume printing or
press the
CLEAR key to clear the counter.
A master is being made.
Wait until it is completed.
There is no document.
Set a document.
The printer is not ready.
Wait a while with the power turned ON. If this
message does not disappear after several minutes,
turn the power OFF and contact service personnel.
The master is not set correctly.
Set the master again.
Turn the power OFF once and turn the power
ON again in several seconds. If the same display
appears, make a memo of the message “Exxx” and
contact service personnel.
ENTER ID AND
PASSWORD
RESET MASTER.ROLL
SERVICE CALL
--WAIT--
PLEASE
MASTER MAKING
--SCANNING--
NO DOCUMENT
--PRINTING--
This message blinks alternately with
the message “Exxx”.
To Next Page
Loading...
Need help?
General