2
2
17
Basic Operations
Preparing for Printing
Adjusting Paper Feed Pressure
Adjust the paper feed pressure if an feeding error occurs when using thick or thin paper.
■When no thick paper is fed
Adjust the paper feed pressure adjuster lever to
“HIGH”.
■When two pieces of thin paper are fed
Adjust the paper feed pressure adjuster lever to
“LOW”.
Make sure that the machine stops.
If printing is in progress, press the
STOP key.
Press the “feed tray descend switch”.
The “feed tray” is lowered for the time that the “feed
tray descend switch” is pressed.
How to Supply or Replace Paper While Printing
If paper runs out during printing or when you replace paper, press the “feed tray descend
switch” to lower the “feed tray”.
REFERENCE
● When supplying different size paper, adjust the
“side fences” and “paper stopper” again.
● When supplying different quality paper, adjust
the “feed pressure adjuster lever” to the paper
thickness.
IMPORTANT
● When paper runs out or papers in the feed tray are
removed, the feed tray is automatically lowered.
Follow steps 2, 3, and 4 in “How to Set Papers”.
(→P.16 “How to Set Papers”)
To Next Page
Loading...
Need help?
General