6
87
Troubleshooting
The message “MASTER SET MISS” is displayed on the LCD panel.
Follow the procedure below to remove a master that is jammed in the feed section, and try
master making again.
When a Master Setting Error Has Occurred
MASTER SET MISS
How to Remove the Master
Open the “ upper cover”.
Upper cover
Remove the “master” that is in the feed section.
Push the “master set lever”.
The master will be pulled in.
● If the master is not pulled in, open the
master cover and gently press in as far as
possible to set again.
IMPORTANT
Master
set lever
To Next Page