EasyManuals Logo

DURAG D-ISC 100 2 Series User Manual

DURAG D-ISC 100 2 Series
212 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #163 background imageLoading...
Page #163 background image
15 | Examples of settings
D-ISC 100 x xx2
163
PIN-Code change
Status: S1.4:Normal measurement
Menu: 5.2.1
1
Enter new PIN-Code
E
PIN-Code change
Status: S1.4:Normal measurement
Menu: 5.2.3
* * *00
Re-enter new PIN-Code
E
Fig.15.11: PIN code menu 5.2.1/5.2.3
Enter the new PIN code here. If must consist of 4 digits in the
value range 0-9.
Information on how to enter the PIN is provided in Section 15.4
Example: Clearing the PIN protection (logging in) [}159] under
PIN input
.
After entering the 4th digit, confirm by pressing the
key. As
usual, you will be requested to enter the new code again for
safety reasons.
Don't forget to memorise or note down the new code.
Without a valid PIN code, you will no longer be able to
change sensitive parameters.
This applies to both the Universal control unit and the connec-
ted sensors with the same PIN.
If you do forget your PIN code, the DURAG Service depart-
ment will be happy to help. You can find the addresses and
telephone numbers on page [}211].
Once you have changed your PIN code, a list will be displayed of
all of the devices logged into the D‑ISC100. There will be a tick
(✓) next to all of the devices that can now be enabled using the
new PIN code (see figure below). There will be a cross (✕) next
to devices that have not had their PIN codes changed.
Fig.15.12: List of devices for which the PIN code has been changed

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DURAG D-ISC 100 2 Series and is the answer not in the manual?

DURAG D-ISC 100 2 Series Specifications

General IconGeneral
BrandDURAG
ModelD-ISC 100 2 Series
CategoryControl Unit
LanguageEnglish

Related product manuals