70
DuraLabel.com 800.788.5572
Troubles hooTing
5. Look into the printer to check whether any sheets of paper are visible on any
part of the belt unit.
Do not use any sharp or abrasive objects to separate sheets from
the belt. This may damage the belt surface.
a. To remove a sheet with its leading edge at the front of the belt (a), lift the
plastic guard (e) at the front of the printer, then carefully lift the sheet from
the belt and pull it forwards into the internal drum cavity and withdraw the
sheet.
a
b
c
d
e
1
2
To Next Page
Loading...
