Maintenance
Operating Instructions 171/173 - 02.0 - 09/2019 61
6 Maintenance
This chapter describes maintenance work that needs to be carried
out on a regular basis to extend the service life of the machine
and achieve the desired seam quality.
Advanced maintenance work may only be carried out by qualified
specialists ( Service Instructions).
Maintenance intervals
WARNING
Risk of injury from sharp parts!
Punctures and cutting possible.
Prior to any maintenance work, switch off the
machine or set the machine to threading mode.
WARNING
Risk of injury from moving parts!
Crushing possible.
Prior to any maintenance work, switch off the
machine or set the machine to threading mode.
Work to be carried out Operating hours
8 40 160 500
Removing lint and thread remnants
Check the oil
Check the lubrication of the looper
Servicing the pneumatic system
To Next Page
Loading...
