Setup
82 Operating Instructions 171/173 - 02.0 - 09/2019
Fig. 47: Assembling the control panel (2)
6. Winkel (4) mit Schrauben (6) auf dem Armdeckel festschrau-
ben.
7. Secure the bracket (4) to the arm cover using the screws (6).
8. Position the arm cover (3) including control panel (5),but DO
NOT tighten yet.
Fig. 48: Assembling the control panel (3)
9. Lay the cable (7) behind the rear of the arm cover.
10. Guide the cable (7) down under the handwheel cover (3).
11. Feed the cable (7) through the tabletop cutout downwards to
the control.
12. Tighten the arm cover (3).
13. Assemble the handwheel cover (2).
(6) - Screws
(7) - Cable
To Next Page
Loading...
