Operation
50 Operating Instructions 745-35-10 S/745-35-10 A - 03.0 - 04/2017
Fig. 41: Inserting the reinforcement strip (4)
10. Insert the reinforcement strip into the feed device (11).
11. Transport the reinforcement strip approx. 20 mm on the fabric sliding
plate (8).
12. Swivel down the fabric sliding plate (8).
13. Press the button.
The reinforcement strip is cut to the correct length.
Information
The tape projection at seam beginning and seam end can be set in the
menu item Pocket parameters ( p. 120).
(5) - Guide
(6) - Reinforcement strip
(7) - Guide
(11) - Feed device
To Next Page
Loading...
