4.9. Print Delay
Indicate the delay from printing trigger to start printing. This decides the position of data printing
on the products.
Making main photocell detects to the edge of products and measuring the distance from printhead
to the data starting position on the products(in mm).
4.10. Print Interval
Indicate the interval of each printing in the mode of continuous printing.
4.11. Print Width
Indicate the horizontal distance between dots in data.
Adjust the height to width ratio of character in printing data and the whole width of data through
this parameter.
4.12. Print Height
The height of printing data can be magnified and shrinked in a certain amount. Please decide this
value according to the printing effect.
4.13. Repeated Trigger
Trigger once is the continuous printing time of current data. This parameter only applies to
“printing trigger” being “photocell edge”.
4.14. Data Bold
Bold the whole data, including the space within the data.
To Next Page
Loading...