F15 Series Fetal & Maternal Monitor Service Manual Disassembling the Monitor
- 51 -
Replace the DC-DC transfer board in a reverse procedure. Refer to the following illustration when
connecting wires. Ensure they are all correctly connected.
1： Power Output Cable Socket
2： Battery Charging Cable Socket
3： Switch Connection Cable Socket
4： NFC Connection wire socket
5： Fan connection socket
9.4.2 Replacing the Fan
To remove the fan,
1) Separate the DC-DC transfer board per section 9.4.1.
2) Remove the four screws on the fan.
3) Disconnect all the wires.
To replace the fan,
Replace the fan in a reverse procedure. Refer to the following illustration when connecting wires.
Ensure they are all correctly connected.
To Next Page
Loading...
