EasyManua.ls Logo

Edge-Core AS6700-32X - Set Community

Edge-Core AS6700-32X
1116 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 29
| IP Routing Commands
Policy-based Routing for BGP
– 1005 –
set community This command sets the community attributes of routing messages. Use the no form
to remove this entry from a route map.
Syntax
set community
[AA:NN...]
[
additive
{[
AA
:
NN...
] [
internet
] [
local-as
] [
no-advertise
] [
no-export
]}
[internet [[AA:NN...] [local-as] [no-advertise] [no-export]]
[local-as [[AA:NN...] [no-advertise] [no-export]]
[no-advertise [AA:NN...] [no-export]]
[no-export [AA:NN...]]
[none]
no set community
AA:NN – Standard community-number. The 4-byte community number is
composed of a 2-byte autonomous system number and a 2-byte network
number, separated by one colon. Each 2-byte number can range from 0
from 65535. One or more communities can be entered, separated by a
space. Up to 16 community numbers are supported.
additive – Adds community attributes to already existing community
attributes.
internet – Specifies the entire Internet. Routes with this community
attribute are advertised to all internal and external peers.
local-as – Specifies the local autonomous system. Routes with this
community attribute are advertised only to peers that are part of the local
autonomous system or to peers within a sub-autonomous system of a
confederation. These routes are not advertised to external peers or to other
sub-autonomous systems within a confederation.
no-advertise – Routes with this community attribute are not advertised to
any internal or external peer.
no-export – Routes with this community attribute are advertised only to
peers in the same autonomous system or to other sub-autonomous
systems within a confederation. These routes are not advertised to external
peers.
none – Delete the community attributes from the prefix of this route.
Command Mode
Route Map
Example
Console(config)#route-map RD permit 11
Console(config-route-map)#match peer 192.168.0.99
Console(config-route-map)#set community 10:01
Console(config-route-map)#exit
Console(config)#route-map RD permit 12
Console(config-route-map)#match peer 192.168.0.99

Table of Contents

Other manuals for Edge-Core AS6700-32X

Related product manuals