Chapter 21
| Data Center Bridging Commands
Priority-based Flow Control Commands
– 552 –
Example
The following example configures port 5 to enable PFC for priorities 3 and 5:
Console(config)#interface ethernet 1/5
Console(config-if)#pfc priority enable 3,5
Console(config-if)#
clear pfc statistics Use this command to clear PFC statistics.
Syntax
clear pfc statistics [interface interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-32/54)
port-channel channel-id (Range: 1-16/27)
Default Setting
None
Command Mode
Privileged Exec
Example
This example clears PFC statistics on all interfaces.
Console#clear pfc statistics
Console#
show pfc Use this command to show PFC configuration settings.
Syntax
show pfc [interface interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-32/54)
port-channel channel-id (Range: 1-16/27)
To Next Page
Loading...
Need help?
General