Edge-Core AS6700-32X - Dst-L4-Port (Ipv4 Hash)

Chapter 29 | IP Routing Commands
Global Routing Configuration
– 812 –
Example
Console(config)#hash-selection list 2 ipv4
Console(config-ipv4-hash-sel)#dst-ip
Console#
dst-l4-port (IPv4 Hash) This command adds the destination Layer 4 protocol port hash attribute to the
hash selection list. Use the no form to remove the specified attribute.
Syntax
[no] dst-l4-port
Command Mode
IPv4 hash selection mode
Example
Console(config)#hash-selection list 2 ipv4
Console(config-ipv4-hash-sel)#dst-l4-port
Console#
protocol-id (IPv4 Hash) This command adds the protocol ID hash attribute to the hash selection list. Use
the no form to remove the specified attribute.
Syntax
[no] protocol-id
Command Mode
IPv4 hash selection mode
Example
Console(config)#hash-selection list 2 ipv4
Console(config-ipv4-hash-sel)#protocol-id
Console#
src-ip (IPv4 Hash) This command adds the source IPv4 address hash attribute to the hash selection
list. Use the no form to remove the specified attribute.
Syntax
[no] src-ip
Command Mode
IPv4 hash selection mode