Edge-Core AS6700-32X - Snmp-Server User

Chapter 5 | SNMP Commands
SNMPv3 Commands
– 193 –
snmp-server user This command adds a user to an SNMP group, restricting the user to a specific
SNMP Read, Write, or Notify View. Use the no form to remove a user from an SNMP
group.
Syntax
snmp-server user username groupname
{v1 | v2c | v3 [encrypted] [auth {md5 | sha} auth-password [priv {3des |
aes128 | aes192 | aes256 | des56} priv-password]]
snmp-server user username groupname remote ip-address
{v3 [encrypted] [auth {md5 | sha} auth-password [priv {3des | aes128 |
aes192 | aes256 | des56} priv-password]]
no snmp-server user username {v1 | v2c | v3| remote ip-address v3}
username - Name of user connecting to the SNMP agent. A maximum of
three local users can be configured. (Range: 1-32 characters)
groupname - Name of an SNMP group to which the user is assigned.
(Range: 1-32 characters)
remote - Specifies an SNMP engine on a remote device.
ip-address - The Internet address of the remote device.
v1 | v2c | v3 - Use SNMP version 1, 2c or 3.
encrypted - Accepts the password as encrypted input.
auth - Uses SNMPv3 with authentication.
md5 | sha - Uses MD5 or SHA authentication.
auth-password - Authentication password. Enter as plain text if the
encrypted option is not used. Otherwise, enter an encrypted password.
(Range: 8-32 characters for unencrypted password)
If the encrypted option is selected, enter an encrypted password.
(Range: 32 characters for MD5 encrypted password, 40 characters for SHA
encrypted password)
priv - Uses SNMPv3 with privacy.
3des - Uses SNMPv3 with privacy with 3DES (168-bit) encryption.
aes128 - Uses SNMPv3 with privacy with AES128 encryption.
aes192 - Uses SNMPv3 with privacy with AES192 encryption.
aes256 - Uses SNMPv3 with privacy with AES256 encryption.
des56 - Uses SNMPv3 with privacy with DES56 encryption.
priv-password - Privacy password. Enter as plain text if the encrypted
option is not used. Otherwise, enter an encrypted password. (Range: 8-32
characters)
Default Setting
None