EasyManuals Logo

Edge-Core AS6700-32X User Manual

Edge-Core AS6700-32X
1116 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #808 background imageLoading...
Page #808 background image
Chapter 29
| IP Routing Commands
Global Routing Configuration
– 808 –
address mask request messages
address mask reply messages
ICMP sent
output
errors
destination unreachable messages
time exceeded messages
parameter problem message
echo request messages
echo reply messages
redirect messages
timestamp request messages
timestamp reply messages
source quench messages
address mask request messages
address mask reply messages
UDP Statistics:
2 input
no port errors
other errors
output
TCP Statistics:
4698 input
input errors
5867 output
Console#
ECMP Commands
ecmp load-balance This command configures the load-balance method used when there are multiple
equal-cost paths to the same destination address in the routing table, including
destinanation IP address with Layer 4 port, or hash selection list.
Syntax
ecmp load-balance {dst-ip-l4-port | hash-selection-list index}
dst-ip-l4-port – Selection based on destination IP address and Layer 4
protocol port.
hash-selection-list – Selection based on hash selection list.
index – Specifies the hash selection list to use for load balancing.
(Range: 1-4)
Default Setting
dst-ip-l4-port
Command Mode
Global Configuration
Command Usage
â—† Equal-cost multi-path (ECMP) routing is a strategy where next-hop packet
forwarding to a single destination can occur over multiple "best paths" which
tie for the top place in routing metric calculations.

Table of Contents

Other manuals for Edge-Core AS6700-32X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Edge-Core AS6700-32X and is the answer not in the manual?

Edge-Core AS6700-32X Specifications

General IconGeneral
BrandEdge-Core
ModelAS6700-32X
CategorySwitch
LanguageEnglish

Related product manuals