– 3 –
How to Use This Guide
This guide includes detailed information on the switch software, including how to
operate and use the management functions of the switch. To deploy this switch
effectively and ensure trouble-free operation, you should first read the relevant
sections in this guide so that you are familiar with all of its software features.
Who Should Read This
Guide?
This guide is for network administrators who are responsible for operating and
maintaining network equipment. The guide assumes a basic working knowledge of
LANs (Local Area Networks), the Internet Protocol (IP), and Simple Network
Management Protocol (SNMP).
How This Guide is
Organized
This guide describes the switch’s command line interface (CLI). For more detailed
information on the switch’s key features refer to the Administrator’s Guide.
The guide includes these sections:
◆ Section I “Getting Started” — Includes information on connecting to the switch
and basic configuration procedures.
◆ Section II “Command Line Interface” — Includes all management options
available through the CLI.
◆ Section III “Appendices” — Includes information on troubleshooting switch
management access.
Related
Documentation
This guide focuses on switch software configuration through the CLI.
For information on how to manage the switch through the Web management
interface, see the following guide:
Web Management Guide
Note:
For a general description of switch features, refer to “Introduction” in the
Web Management Guide.
For information on how to install the switch, see the following guide:
Installation Guide
To Next Page
Loading...
Need help?
General