Chapter 4
| System Management Commands
System Status
– 124 –
Operation Code Version : 1.0.102.152
Console#
show watchdog This command shows if watchdog debugging is enabled.
Command Mode
Privileged Exec
Example
Console#show watchdog
Software Watchdog Information
Status : Enabled
Console#
watchdog software This command monitors key processes, and automatically reboots the system if any
of these processes are not responding correctly.
Syntax
watchdog software {disable | enable}
Default Setting
Disabled
Command Mode
Privileged Exec
Table 15: show version – display description
Parameter Description
Serial Number The serial number of the switch.
Hardware Version Hardware version of the main board.
EPLD Version Version number of Erasable Programmable Logic Device.
Number of Ports Number of built-in ports.
Main Power Status Displays the status of the internal power supply.
Redundant Power Status Displays the status of the redundant power supply.
(This switch does not support a redundant power supply.
Role Shows that this switch is operating as Master or Slave.
Loader Version Version number of loader code.
Linux Kernel Version Version number of Linux kernel.
Operation Code Version Version number of runtime code.
To Next Page
Loading...
Need help?
General