Chapter 5
| SNMP Commands
Additional Trap Commands
ā 201 ā
show nlm oper-status This command shows the operational status of configured notification logs.
Command Mode
Privileged Exec
Example
Console#show nlm oper-status
Filter Name: A1
Oper-Status: Operational
Console#
show snmp
notify-filter
This command displays the configured notification logs.
Command Mode
Privileged Exec
Example
This example displays the configured notification logs and associated target hosts.
Console#show snmp notify-filter
Filter profile name IP address
---------------------------- ----------------
A1 10.1.19.23
Console#
Additional Trap Commands
memory This command sets an SNMP trap based on configured thresholds for memory
utilization. Use the no form to restore the default setting.
Syntax
memory {rising rising-threshold | falling falling-threshold}
no memory {rising | falling}
rising-threshold - Rising threshold for memory utilization alarm expressed in
percentage. (Range: 1-100)
falling-threshold - Falling threshold for memory utilization alarm expressed
in percentage. (Range: 1-100)
Default Setting
Rising Threshold: 90%
Falling Threshold: 70%
Command Mode
Global Configuration
To Next Page
Loading...
