Chapter 8
| General Security Measures
Network Access (MAC Address Authentication)
– 273 –
Default Setting
Displays the settings for all interfaces.
Command Mode
Privileged Exec
Example
Console#show network-access interface ethernet 1/1
Global secure port information
Reauthentication Time : 1800
MAC Address Aging : Enabled
Port : 1/1
MAC Authentication : Disabled
MAC Authentication Intrusion Action : Block traffic
MAC Authentication Maximum MAC Counts : 1024
Maximum MAC Counts : 2048
Dynamic VLAN Assignment : Enabled
Dynamic QoS Assignment : Disabled
MAC Filter ID : Disabled
Guest VLAN : Disabled
Link Detection : Disabled
Detection Mode : Link-down
Detection Action : Trap
Console#
show network-access
mac-address-table
Use this command to display secure MAC address table entries.
Syntax
show network-access mac-address-table [static | dynamic]
[address mac-address [mask]] [interface interface] [sort {address |
interface}]
static - Specifies static address entries.
dynamic - Specifies dynamic address entries.
mac-address - Specifies a MAC address entry. (Format: xx-xx-xx-xx-xx-xx)
mask - Specifies a MAC address bit mask for filtering displayed addresses.
interface - Specifies a port interface.
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-32/54)
sort - Sorts displayed entries by either MAC address or interface.
Default Setting
Displays all filters.
To Next Page
Loading...
Need help?
General