Edge-Core AS6700-32X - Traffic-Segmentation Session

Chapter 8 | General Security Measures
Port-based Traffic Segmentation
– 332 –
traffic-segmentation
session
This command creates a traffic-segmentation client session. Use the no form to
remove a client session.
Syntax
[no] traffic-segmentation session session-id
session-id – Traffic segmentation session. (Range: 1-4)
Default Setting
None
Command Mode
Global Configuration
Command Usage
◆ Use this command to create a new traffic-segmentation client session.
◆ Using the no form of this command will remove any assigned uplink or
downlink ports, restoring these interfaces to normal operating mode.
Example
Console(config)#traffic-segmentation session 1
Console(config)#
traffic-segmentation
uplink/downlink
This command configures the uplink and down-link ports for a segmented group of
ports. Use the no form to remove a port from the segmented group.
Syntax
[no] traffic-segmentation [session session-id] {uplink interface-list
[downlink interface-list] | downlink interface-list}
session-id – Traffic segmentation session. (Range: 1-4)
uplink – Specifies an uplink interface.
downlink – Specifies a downlink interface.
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-32/54)
port-channel channel-id (Range: 1-16/27)
Default Setting
Session 1 if not defined
No segmented port groups are defined.