Chapter 30
| Multicast Routing Commands
PIM Multicast Routing
– 1023 –
PIM Shared Mode Commands
router pim This command enables IPv4 Protocol-Independent Multicast routing globally on
the router. Use the no form to disable PIM multicast routing.
Syntax
[no] router pim
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
â—† This command enables PIM-DM and PIM-SM globally for the router. You also
need to enable PIM-DM or PIM-SM for each interface that will support multicast
routing using the ip pim dense-mode or ip pim sparse mode command, and
make any changes necessary to the multicast protocol parameters.
PIM-SM Commands
ip pim bsr-candidate Configures the switch as a Bootstrap Router (BSR)
candidate
GC
ip pim register-rate-limit Configures the rate at which register messages are sent by
the Designated Router (DR)
GC
ip pim register-source Configure the IP source address of a register message to an
address other than the outgoing interface address of the
designated router (DR) leading toward the rendezvous
point (RP)
GC
ip pim rp-address Sets a static address for the rendezvous point GC
ip pim rp-candidate Configures the switch rendezvous point (RP) candidate GC
ip pim spt-threshold Prevents the last-hop PIM router from switching to
Shortest Path Source Tree (SPT) mode
GC
ip pim ssm range Sets the range for source-specific multicast addresses GC
ip pim dr-priority Sets the priority value for a DR candidate IC
ip pim join-prune-interval Sets the join/prune timer IC
clear ip pim bsr rp-set Clears RP entries learned through the BSR PE
show ip pim bsr-router Displays information about the BSR PE
show ip pim rp mapping Displays active RPs and associated multicast routing
entries
PE
show ip pim rp-hash Displays the RP used for the specified multicast group PE
show ip pim ssm range Displays the range for source-specific multicast addresses PE
Table 200: PIM-DM and PIM-SM Multicast Routing Commands (Continued)
Command Function Mode
To Next Page
Loading...
Need help?
General