Edge-Core AS6700-32X - General Commands

Chapter 7 | Authentication Commands
802.1X Port Authentication
– 241 –
General Commands
dot1x default This command sets all configurable dot1x authenticator global and port settings to
their default values.
Command Mode
Global Configuration
Example
Console(config)#dot1x default
Console(config)#
dot1x eapol-pass-
through
This command passes EAPOL frames through to all ports in STP forwarding state
when dot1x is globally disabled. Use the no form to restore the default.
Syntax
[no] dot1x eapol-pass-through
Default Setting
Discards all EAPOL frames when dot1x is globally disabled
Command Mode
Global Configuration
Command Usage
This command resets the following commands to their default settings:
◆ dot1x system-auth-control
◆ dot1x eapol-pass-through
◆ dot1x port-control
◆ dot1x port-control multi-host max-count
◆ dot1x operation-mode
◆ dot1x max-req
◆ dot1x timeout quiet-period
◆ dot1x timeout tx-period
◆ dot1x timeout re-authperiod
◆ dot1x timeout sup-timeout
◆ dot1x re-authentication
◆ dot1x intrusion-action