Chapter 29
| IP Routing Commands
Border Gateway Protocol (BGPv4)
– 984 –
show ip bgp paths This command shows all paths in the database.
Syntax
show ip bgp paths
Command Mode
Privileged Exec
Example
Console#show ip bgp paths
Address RefCnt ASpath
0x331dad0:0 1
0x331d850:93 1 600
0x331d8d8:249 2 200 300
Console#
keepalive interval Interval at which keepalive messages are transmitted to this neighbor.
Neighbor capabilities BGP capabilities advertised and received from this neighbor.
Message statistics Statistics organized by message type.
Minimum time
between
advertisement runs
Time between transmission of advertisements.
For address family Address family to which the following information refers.
Local host/port IP address and TCP port of the local BGP speaker.
Foreign host/port IP address and TCP port of the neighbor BGP speaker.
Nexthop IP address of next system via which packets are forwarded to the destination
network.
Read thread The read status for the socket connection with this neighbor.
Write thread The write status for the socket connection with this neighbor.
Table 189: show ip bgp - display description (Continued)
Field Description
Table 190: show ip bgp paths - display description
Field Description
Address Internal address in memory where the path is stored.
Refcnt The number of routes using this path.
ASpath The autonomous system path for this route.
To Next Page
Loading...
Need help?
General