Edge-Core AS6700-32X - Maximum-Paths

Chapter 29 | IP Routing Commands
Global Routing Configuration
– 810 –
maximum-paths This command sets the maximum number of paths allowed. Use the no form to
restore the default settings.
Syntax
maximum-paths path-count
no maximum-paths
path-count - The maximum number of equal-cost paths to the same
destination that can be installed in the routing table. (Range: 1-8)
Command Mode
Global Configuration
Example
Console(config)#maximum-paths 8
Console(config)#
dst-mac (MAC Hash) This command adds the dst-mac address hash attribute to the hash selection list.
Use the no form to remove the specified attribute.
Syntax
[no] dst-mac
Command Mode
MAC hash selection mode
Example
Console(config)#hash-selection list 1 mac
Console(config-mac-hash-sel)#dst-mac
Console#
ethertype (MAC Hash) This command adds the EtherType hash attribute to the hash selection list. Use the
no form to remove the specified attribute.
Syntax
[no] ethertype
Command Mode
MAC hash selection mode