Electrolux E36DF76EPS - Removing the Interface Board; Removing the Function Selector; Removing the Top Burner Igniter Switch; Removing the Top Burner Valve

100
3. Remove the two screws holding the temperature
selector to the control mounting plate, push the
control forward and to the side, and pull the control
out.
Removing the interface board:
1. Disconnect power and remove the control panel.
2. Remove the two screws holding the interface
board to the control mounting plate, turn the board
and lift it out.
Removing the function selector:
1. Disconnect power and remove the control panel.
2. Remove the function selector knob.
3. Remove the two screws holding the function
selector to the control mounting plate, push the
control forward and to the side, and pull the control
out.
Removing the top burner igniter switch:
1. Disconnect power and remove the control panel.
2. Disconnect the wire from the switch, remove the (2)
screws holding the switch to the valve and lift the
switch off.
out.
Removing the top burner valve:
1. Disconnect power, turn off the gas supply and
remove the control panel.