35
Getting Started
BEFORE SETTING OVEN CONTROLS
Installing and Removing Oven Rack
Supports
ALWAYS INSTALL OVEN RACK SUPPORT BEFORE
TURNING ON THE OVEN (WHEN THE OVEN IS
COOL).
To install oven rack support, align and insert the 2
rear tabs of the rack supports to the rear holes in the
oven side wall.
Then align the 2 front tabs of the rack support to the
front holes in the oven side wall. Push in on rack sup-
ports to secure in wall.
To remove the oven rack support for a self-clean
cycle, support and lift front bottom of rack support to
release front tabs. Then, rotate rack support up and
out to release rear tabs. If the rack supports are not
removed, the self-clean cycle won’t start.
Removing and Replacing Oven Racks
ALWAYS ARRANGE OVEN RACKS WHEN THE
OVEN IS COOL (PRIOR TO OPERATING THE OVEN).
Always use oven mitts when using the oven. To remove
an oven rack, pull the rack forward. Lift up the rack off
the oven rack glides. To install an oven rack, locate
the two pinholes in the small plates at the front corners
of the rack. Position the back of the rack on the rack
glides and drop the pin holes over the pins on the rack
glides.
To Next Page
Loading...
Need help?
General
