104
2. Remove the (2) screws holding the smoke
eliminator to the top of the oven and drop the
eliminator into the oven.
Removing the oven sensor:
1. Remove the pressure regulator access panel and
disconnect the (2) sensor wires.
2. Remove the (2) screws holding the oven sensor to
the rear wall of the oven and pull the sensor and the
wires out. Went reinstalling the sensor push the
wires back through the hole and pull them tight from
the rear of the oven.
Removing the rack support:
1. Open the oven door.
2. Lift up and out on the bottom front corner of the
support to disengage it from the side of the oven.
Removing the oven light:
1. Open the oven door and remove the rack support.
To Next Page
Loading...
Need help?
General
