109
5. Grab the bottom rear corner of the side panel and
rotate the side panel counterclockwise until the front
edge of the side panel is parallel with the edge of the
burner box. Then, pullout on the front corner of the
side panel to disengage it from the burner box.
Removing the side fillers (36” model):
1. Disconnect power, remove the side panel and the
manifold disconnect panel.
2. Remove the (3) screws holding the filler to the burner
box.
3. Remove the (7) screws, four in the front and three
in the rear, holding the filler to the side of the oven.
To Next Page
Loading...
