50
PROBLEM
Burners ignite but flame is
extremely large, distorted or
yellow.
Burner flame goes out at low
setting.
Ignitors spark continuously
after flame ignition.
POSSIBLE CAUSE
Burner ring ports are clogged.
Burner ports or burner caps are not
positioned properly.
Cooktop is being operated on the
wrong type of gas.
Regulator is not installed, is faulty or
is set for the wrong type of gas.
Low gas supply pressure.
Power supply is not grounded.
Power supply polarity is reversed.
Ignitors are wet or dirty.
SOLUTION
Clean burner ring ports with straight-
ened paper clip, needle or wire.
Remove and carefully re-install
burner rings and caps.
Ensure that the type of cooktop
matches the gas supply (natural gas
or L.P. gas)
Check installation, replace regullator,
or set regulator for proper gas.
Contact gas company.
Have power supply properly
grounded.
Have polarity corrected.
Dry or clean ignitors.
To Next Page
Loading...
Need help?
General
