Emerson Aventics G3 Series - Analog Module: Factory Defaults Reset

G3 Series EtherCAT
TM
Technical Manual
10-103
TDG3ECM1-5EN 07/2020
Subject to change without notice
www.asco.com/g3
Analog Module / Factory Defaults
FACTORY DEFAULT SETTINGS
Description Default
Low Alarm Values 0 V / 4 mA
High Alarm Values 10 V / 20 mA
Brightness Medium
Factory Default Settings
1. Press the SET button to enter the FACTORY DEFAULTS
sub-menu.
2. Press the NEXT button to select Yes or No.
a. Selecting No will bring you back to the main
FACTORY DEFAULTS menu.
b. Selecting Yes will cause the module to reset and
return all parameters to the factory default
conditions.
Press the SET button to confirm your choice.
FACTORY
DEFAULTS
SET DEFAULTS
YES N0