Emerson Aventics G3 Series - Twincat IP Communication Configuration

G3 Series EtherCAT
TM
Technical Manual
14-152
TDG3ECM1-5EN 07/2020
Subject to change without notice
www.asco.com/g3
Twincat configuration for IP communication over EtherCAT
TM
(Beckhoff PLC)
This configuration is required for a PC to communicate with the G3 node web page through the EtherCAT
TM
master
device.
Expand the “Numatics G3” Box (device)
Select the EtherCAT
TM
tab
Click advanced settings