G3 Series EtherCAT
TM
Technical Manual
5-40
Subject to change without notice
www.asco.com/g3
Advanced Settings - Diagnostic Word
This will allow the enabling / disabling of the Diagnostic Word Status bits. The Diagnostic word data includes power
status and sub-bus related status bits. Detailed information regarding these bits can be found on page 15-178. The
Diagnostic Word comes enabled from the factory.
Diag. Word Status Settings
1. Press the SET button to enter the ADVANCED SETTINGS menu.
2. Press the SET button to enter the ADVANCED MENU /SET STATUS.
3. Press the NEXT button to scroll to the SET STATUS / DIAG WORD
menu.
Press the SET button to enter the SET STATUS / DIAG WORD menu.
4. The current state of the parameter is shown.
5. Press the SET button to change this parameter
Use the NEXT button to scroll through the choices to enable/disable
the Diagnostic Word status for.
a. ENABLED (Factory Default)
b. DISABLED
c. RETURN (this will return you to the SET STATUS menu)
Press the SET button to confirm your choice.
6. Press NEXT to confirm the warning message.
7. Press the NEXT button to select Yes or No to accept the selection
a. Selecting No will bring you back to the main SET STATUS
menu.
b. Selecting Yes will take you to the following saved settings
menu.
Press the SET button to confirm your choice.
Save Settings Steps
8. Press the NEXT button to select either NOW or LATER.
a. Selecting NOW will cause the node to reset and apply the
new setting.
b. Selecting LATER will cause the new NODE DIAG selection
to be saved in memory, you must Accept the saved
changes before your next power cycle otherwise they will
be lost.
Press the SET button to confirm your choice.
SETTINGS
SET STATUS
IO STATUS
DIAG WORD
ENABLED
DISABLED
RETURN
WILL SHIFT!
DISABLED Y N
NOW LATER
ENABLED
To Next Page
Loading...
Need help?
General
