Emerson Aventics G3 Series User Manual

G3 Series EtherCAT
TM
Technical Manual
5-36
TDG3ECM1-5EN 07/2020
Subject to change without notice
www.asco.com/g3
Web-Server
This will allow the enabling/disabling of the G3 Web Server.
NOTE!
Web-Server Steps
1. Press the SET button to enter the Web-Server sub-menu.
2. Press the NEXT button to scroll through the choices to
enable or disable the feature.
a. ENABLED (Factory Default)
b. DISABLED
c. RETURN (this will return you to the main menu)
Press the SET button to confirm your choice.
3. Press the NEXT button to select Yes or No to accept the
selection.
a. Selecting No will bring you back to the main
menu.
b. Selecting Yes will take you to the following apply
changes menu.
Press the SET button to confirm your choice.
Apply Changes Steps
4. Press the NEXT button to select either NOW or LATER.
a. Selecting NOW will cause the node to reset and
apply the new setting.
b. Selecting LATER will cause the new setting to be
saved in memory, you must accept the saved
changes before your next power cycle otherwise
they will be lost.
Press the SET button to confirm your choice.
• Factory default setting for WEB-SERVER is enabled.
WEB-SERVER
ENABLED
WEB-SERVER
DISABLED
WEB-SERVER
ENABLED
WEB-SERVER
RETURN
ACCEPT
ENABLED Y N
ACCEPT
ENABLED Y N
SAVE SETTINGS
NOW LATER

Emerson Aventics G3 Series Specifications

General

Brand	Emerson
Model	Aventics G3 Series
Category	Industrial Equipment
Language	English