Safety
Information
Introduction Installation
PowerTools
Pro Software
Communications
How
Motion
Works
How I/O
Works
Configuring
an
Application
Programming
Starting and
Stopping
Motion
Starting and
Stopping
Programs
Parameter
Descriptions
Drive
Parameters
Used by
EZMotion
Diagnostics Glossary Index
EZMotion User/Programming Guide 103
Revision A8 www.controltechniques.com
The Level Off Timer does not use the Reset, but rather, the Output will remain OFF as long as the Input remains OFF.
Figure 106: Level Off Timer - Timing Diagram
Cumulative ON Timer
This type of timer works exactly like the Level ON Timer, except that if the Input turns OFF before the Preset time is reached,
the elapsed time is not reset. The total time that the Input is ON is added together such that when the total time of the Input
being ON reaches the Preset time, the Output turns ON. Figure 6 below shows an example timing diagram of the Cumulative
On Timer.
Figure 107: Cumulative ON Timer, No Reset - Timing Diagram
Additionally, a Reset signal can be used to clear the cumulative timer and restart it at zero. The figure below shows an
To Next Page
Loading...
