Safety
Information
Introduction Installation
PowerTools
Pro Software
Communications
How
Motion
Works
How I/O
Works
Configuring
an
Application
Programming
Starting and
Stopping
Motion
Starting and
Stopping
Programs
Parameter
Descriptions
Drive
Parameters
Used by
EZMotion
Diagnostics Glossary Index
EZMotion User/Programming Guide 205
Revision A8 www.controltechniques.com
Jog Decelerating
Jog.#.Decelerating
This source turns on at the beginning of a jog deceleration ramp and turns off at the completion of the ramp.
Jog Initiate Minus
Jog.#.MinusInitiate
This is used inside a program to initiate a specific jog. When this bit is active, jogging motion will be initiated in the negative
direction at the specified jog velocity.
Jog Initiate Plus
Jog.#.PlusInitiate
This is used inside a program to initiate a specific jog. When this bit is active, jogging motion will be initiated in the positive
direction at the specified jog velocity.
Jog Time Base
Jog.#.TimeBase
The time base selects either realtime, which allows velocities, acceleration and deceleration to be based on real time, or
synchronized, which allows for an external synchronization signal.
Jog Velocity
Jog.#.Vel
This parameter specifies the velocity used for jogging with the Jog.PlusActivate and Jog.MinusActivate destinations or the
Jog.#.PlusInitiate and Jog.#.MinusInitiate inside a program. The units for this parameter are specified in the User Units view.
Master Absolute Home Defined
MasterAxis.AbsHomeDefined
See Absolute Home Defined. This parameter is a duplicate of Absolute Home Defined, except it applies to the Master Axis
absolute position feedback instead of the Motor Axis.
Master Absolute Home Position Decimal Places
MasterAxis.AbsHomePosnDecimalPlaces
See Absolute Home Position Decimal Places. This parameter is a duplicate of Absolute Home Position Decimal Places,
except it applies to the Master Axis instead of the Motor Axis.
Master Absolute Home Position in User Units
MasterAxis.AbsHomePosnUserUnits
See Absolute Home Position in User Units. This parameter is a duplicate of Absolute Home Position in User Units, except it
applies to the Master Axis instead of the Motor Axis.
Master Absolute Home Rev Count
MasterAxis.AbsHomeRevCount
See Absolute Home Rev Count. This parameter is a duplicate of Absolute Home Rev Count, except it applies to the Master
Axis instead of the Motor Axis.
Master Absolute Home Rev Position
MasterAxis.AbsHomeRevPosn
See Absolute Home Rev Position. This parameter is a duplicate of Absolute Home Rev Position, except it applies to the
Master Axis instead of the Motor Axis.
Master Absolute Position Auto-Calculate Enable
MasterAxis.AbsPosnAutoCalculateEnable
See Absolute Position Auto-Calculate Enable. This parameter is a duplicate of Absolute Position Auto-Calculate Enable,
except it applies to the Master Axis instead of the Motor Axis.
Master Absolute Position Mode
MasterAxis.AbsPosnMode
See Absolute Position Mode. This parameter is a duplicate of Absolute Position Mode, except it applies to the Master Axis
To Next Page
Loading...
