12 Transmitter operation
Topics covered in this chapter:
•
Record the process variables
•
View process variables and diagnostic variables
•
View and acknowledge status alerts
12.1 Record the process variables
Micro Motion suggests that you make a record of specific process variable measurements,
including the acceptable range of measurements, under normal operating conditions. This
data will help you recognize when the process or diagnostic variables are unusually high or
low, and may help you diagnose and troubleshoot application issues.
Procedure
Record the following process and diagnostic variables, under normal operating conditions.
Variable
Measurement
Typical average Typical high Typical low
Specific Gravity, Molecular
Weight, or Relative Density
Line Temperature
Line Pressure
Sensor Time Period
Pickoff Voltage
Drive Gain
12.2 View process variables and diagnostic variables
Process variables provide information about the state of the process fluid. Diagnostic
variables provide data about meter operation. This information can be used to understand
and troubleshoot your process.
12.2.1
View process variables and other data using ProLink III
Monitor process variables, diagnostic variables, and other data to maintain process quality.
Transmitter operation
Configuration and Use Manual 123
To Next Page
Loading...
