14.25 Locate a device using the HART 7 Squawk
feature
The Squawk feature causes the device to show a specific pattern on its display. You can use
this to locate or identify a device.
Restriction
The Squawk feature is available only with HART 7 connections. It is not available with ProLink III.
Procedure
1. Choose Service Tools > Maintenance.
2. Click Locate Device, then click Next.
An 0-0-0-0 pattern is shown on the display.
To return to the normal display, activate either Scroll or Select, or wait 60 seconds.
Troubleshooting
Configuration and Use Manual 171
To Next Page
Loading...
