To Next Page

To Previous Page

k. Set Mass Flow Rate Unit to the unit to be used for Mass Flow (Calculated).

5. (Optional) To configure Mass Flow (External) and Volume Flow (Calculated):

a. Choose Configure > Manual Setup > Inputs/Outputs > External Device Polling.

b. Choose an unused polling slot.

c. Set Poll Control to Poll as Primary or Poll as Secondary.

d. Set External Device Tag to the HART tag of the external measurement device.

e. Set Polled Variable to Mass Flow from Coriolis Meter.

f. Choose Configure > Manual Setup > Measurements > Optional Setup > External

Inputs > Configure External Inputs > Mass.

g. Set Mass Flow Source to Enable.

h. Choose Configure > Manual Setup > Measurements > Mass.

i. Set Mass Flow Rate Unit to the unit used by the external device.

j. Choose Configure > Manual Setup > Measurements > Gas Standard Volume.

k. Set GSV Flow Unit to the unit to be used for Volume Flow (Calculated).

8.4 Set up concentration measurement using the

Field Communicator

This section guides you through the tasks required to set up, configure, and implement

concentration measurement.

1. Enable the concentration measurement application using the Field Communicator

(Section 8.4.1)

2. Configure a concentration measurement matrix using the Field Communicator

(Section 8.4.2)

3. Select the active concentration matrix using the Field Communicator (Section 8.4.3)

8.4.1

Enable the concentration measurement application

using the Field Communicator

The concentration measurement application must be enabled before you can perform any

setup. If the concentration measurement application was enabled at the factory, you do

not need to enable it now.

1. Choose Overview > Device Information > Applications > Enable/Disable Applications.

2. Enable the concentration measurement application.

Configure process measurement using the Field Communicator

82 Micro Motion

Gas Specific Gravity Meters (SGM)

Emerson Micro Motion SGM Series User Manual

Questions and Answers: