9.2 Enable or disable the Acknowledge All Alerts display command .................................................88
9.3 Configure security for the display menus ...................................................................................88
9.4 Configure alert handling ............................................................................................................ 89
9.4.1 Configure Fault Timeout ..............................................................................................90
9.4.2 Configure Alert Severity .............................................................................................. 90
9.5 Configure informational parameters ..........................................................................................93
Chapter 10 Integrate the meter with the control system ................................................................ 95
10.1 Configure Channel B .................................................................................................................. 95
10.2 Configure the mA output ........................................................................................................... 96
10.2.1 Configure mA Output Process Variable ........................................................................96
10.2.2 Configure Lower Range Value (LRV) and Upper Range Value (URV) ............................. 99
10.2.3 Configure Added Damping ........................................................................................100
10.2.4 Configure mA Output Fault Action and mA Output Fault Level .................................. 101
10.3 Configure the discrete output ..................................................................................................102
10.3.1 Configure Discrete Output Source .............................................................................103
10.3.2 Configure Discrete Output Polarity ............................................................................104
10.3.3 Configure Discrete Output Fault Action .....................................................................104
10.4 Configure an enhanced event .................................................................................................. 105
10.5 Configure HART/Bell 202 communications ............................................................................. 106
10.5.1 Configure basic HART parameters ............................................................................. 107
10.5.2 Configure HART variables (PV, SV, TV, QV) ................................................................ 108
10.5.3 Configure burst communications .............................................................................. 110
10.6 Configure Modbus communications ........................................................................................ 114
10.7 Configure Digital Communications Fault Action .......................................................................115
10.7.1 Options for Digital Communications Fault Action ......................................................116
Chapter 11 Complete the configuration ....................................................................................... 117
11.1 Test or tune the system using sensor simulation ...................................................................... 117
11.2 Back up transmitter configuration ........................................................................................... 117
11.3 Enable HART security ............................................................................................................... 118
Part III Operations, maintenance, and troubleshooting
Chapter 12 Transmitter operation ................................................................................................ 123
12.1 Record the process variables ....................................................................................................123
12.2 View process variables and diagnostic variables ....................................................................... 123
12.2.1 View process variables and other data using ProLink III ..............................................123
12.2.2 View process variables using the Field Communicator ...............................................124
12.3 View and acknowledge status alerts .........................................................................................124
12.3.1 View and acknowledge alerts using ProLink III ........................................................... 124
12.3.2 View alerts using the Field Communicator .................................................................125
12.3.3 Alert data in transmitter memory .............................................................................. 125
Chapter 13 Measurement support ................................................................................................127
13.1 Perform the Known Density Verification procedure ................................................................. 127
13.1.1 Perform the Known Density Verification procedure using ProLink III ..........................127
13.1.2 Perform the Known Density Verification procedure using the
Field Communicator ..................................................................................................128
13.2 Configure temperature compensation .....................................................................................129
13.2.1 Configure temperature compensation using ProLink III ............................................. 129
13.2.2 Configure temperature compensation using the Field Communicator ...................... 130
Contents
Configuration and Use Manual iii
To Next Page
Loading...
Need help?
General
